Parallel Connection - Amate Audio Joker Active Systems Manual De Usuario

Joker Active systems
J) AC LINK: Grey connector to feed other units in parallel. Linking up to 10 units is
possible, provided that a quality cable of a minimum section of 3x2.5mm
Connecting more than 10 units in parallel may lead to a voltage drop in the cable that
will reduce the equipment performance.
2.2. Configurations

2.2.1. Parallel connection

Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for
further units. All of the units in this chain must be switched on.
For the mains connection use the cable with the blue Neutrik PowerCon NAC3FCA.
You can use the mains connection in parallel by using a cable with grey Neutrik
PowerCon NAC3FCB at one end and the blue Neutrik PowerCon NAC3FCA at the
other end.
Do not connect Joker series units using PowerCon without earth.
Do not connect more than ten units using the AC output link connector.
Fig.2. Parallel connection for Joker cabinets (signal and mains)
2.2.2 Parallel connection with subwoofer
You can connect the Joker subwoofers in parallel with Joker full range cabinets.
Please, follow the same parameters as explained in figure 2.
19
Oct 2015
2
is used.
Amate Audio