Idiomas disponibles
Idiomas disponibles
INSTALLING C0
CYLINDER AND REGULATOR
2
Make certain that all fittings in system are tight. Always keep the CO
in vertical position. The recommended pressure for the CO
INSTALL DRAFT ARM
1. Place rubber washer over draft arm mounting holes in cabinet, put beer line
connector down through hole.
2. Next, secure draft arm with four screws.
3. Insert air hose (one inch plastic tube) in draft arm, being careful not to disturb
insulation. Remove top cover of draft arm and attach air hose clip to the insulating
sleeve at the top of the draft arm. Replace top cover.
4. The air hose clip will assure that the hose remains in proper place at all times,
keeping the beer faucet cold.
ONE DOOR C0
KNOCK-OUT
2
This instruction is the procedure for installing a remote CO
door unit.
REQUIRED TOOLS:
•
Pliers
•
Power Drill
•
Silicone Sealer
•
Drill bit, 1/2"
1. Remove black knockout plug with a pair of pliers.
NOTE: Knockout plug for CO
2
diagram to locate these two areas.
2. Use drill and bit to bore hole straight back through wall into compressor
compartment.
3. Snake CO
line through hole down and around exiting behind rear castor
2
underneath rear grill.
4. Seal hole around CO
line with silicone sealer to prevent cold air leakage.
2
5
BEER DISPENSERS
system is 8-10 psi.
2
container for one
2
line can be locate in two different areas. View
cylinder
2
