Perles MG 110 Manual Original página 11



with different application tools or is poorly maintained, the
vibration level and noise emission value may differ. This
may significantly increase the vibration and noise
emissions over the total working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running
but not actually being used should also be taken into
account. This may significantly reduce vibration and noise
emissions over the total working period.
Implement additional safety measures to protect the
operator from the effects of vibration, such as servicing
the power tool and application tools, keeping their hands
warm, and organising workflows correctly..
OPERATING CONTROLS
Switch ON/OFF
Lock button
Speed selection button
Gear selector
Mixer spindle
Mixer neck
Stirrer paddle
Handles
STANDARD EQUIPMENT
MG 110 MG 120
Stirrer Stirrer
paddle paddle
WK120 MK140
ACCESSORIES
For your safety, and to ensure efficient operation, use only
original accessories. These can be obtained from your
dealer.
EXPLANATION OF SYMBOLS
You must read safety instructions and general
safety instructions.
Wear a protection mask.
Wear eye protection.
Wear protective gloves.
Wear ear protection.
Double isolation of the tool.
Warning: Risk of personal injuries and damages
to objects.
Warning: Danger of electric shock.
Symbol for separate collection of electric and
electronic waste.



MG 122 MG 162
Stirrer Stirrer
paddle paddle
MK140 MK160


USE
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine
Setting the stirrer paddle
The mixer spindle
paddle has a thread so that you can simply screw on
the stirrer paddle to the spindle by hand. When the stirrer
paddle is screwed on to the nut, fasten it with two fork
spanners No. 19 and No. 24 (or 22). You can dismantle
the stirrer paddle in the same way only in the opposite
direction.
Switching On and Off
Hold the mixer handles with both hands and put the stirrer
paddle into the substance you want to mix.
The power tool is started and stopped as follows :
Start: press switch button
To lock on
push and hold the On/Off switch
and press the lock-on button
Stop To switch off the machine, release the
On/Off switch
then
Speed control
The mixer is equipped with an electronic switch so that
the mixer's speed increases slowly as you push the switch
on button . This way you avoid the excessive dusting of
the surroundings and that is usually the case when one
starts mixing and the entire substance is not wet yet.
Be careful when mixing that the stirring part of the mixer is
always entirely immersed into the substance and this way
you avoid splashing.
Releasing the switch on button you reduce the mixer's
speed. When you release the button till the end, the mixer
stops.
To adjust the speed
The maximum speed (n
the wheel .
n MG 120
0
1 180
2 270
3 360
4 460
5 540
6 590
Gear change : MG 122, MG 162
Mixers have two gears and therefore you can adjust the
mixer's revolutions to the substance you mix. The lower
number of revolutions is used for thick substances, and
the higher number
substances. It is important that you do not use the higher
speed for the thickest materials as this overloads the
motor and lessens its life, and eventually even the motor
can break down.

11
has a thread hole, and the stirrer
or push and release it
.
: MG 120, MG 122, MG 162
) is set by changing the position of
0
MG 122 MG 162
I II I
190 290 150
230 320 220
310 430 290
380 530 350
460 630 430
520 720 470
of revolutions for thin liquid



.
II
210
300
410
510
610
680
