Idiomas disponibles
Idiomas disponibles
×
Remove all parts from the rear axle.
1-2. Fit the wheel driver to the wheel. Insert and tigthen three Ø4x16 screws to secure the wheel driver
to the wheel.
3. Slide the wheel onto the rear axle (Left Side). Keep the wheel driver match up with the gear box on
the rear axle.
4. Slide a Ø10 washer onto the rear axle.
5. Tighten a lock nut to the end of the rear axle with a spanner.
Repeat the above procedure to assemble the other Rear Wheel.
HINT: An extra spanner has been provided to hold the Lock Nut on the other side of the rear axle while
tightening the Lock Nut on the other side.
6. Fit the hub caps to the wheels.
ATTACH THE FRONT WHEELS
4
5
×
Remove all parts from the rear axle.
1. Slide a Ø10 washer onto the front axle.
2. Slide a wheel onto the front alxe.
3. Slide a Ø10 washer onto the front axle.
4. Tighten a lock nut to the end of the front axle with a spanner. DO NOT over tighten.
5. "Snap" the hubcap to the wheel.
Repeat the above procedure to assemble the other Front Wheel.
2
3
1
51
Front Bottom View
Front Bottom View
EN
