Idiomas disponibles
Idiomas disponibles
Fig. 16
Pull
Telescoping lock
3. Lock the pole in position by closing the telescoping lock
(Fig. 17), and ensure that the pole is secured.
Fig. 17
m
WARNING!
Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The pole chain saw head can be rotated for different cutting
angles for 0º, 15º, and 30º (Fig. 18). Follow the below
instructions to adjust angles.
Fig. 18
1. Rotate the chain saw head to the desired cutting angle
while pressing the rotating buttons located on both sides
simultaneously (Fig. 19).
Pull
Telescoping lock
0º
15º
30º
Fig. 19
Front Side
Rotating button
2. Release the buttons when the chain saw head is set to the
desired angle.
NOTE: Failure to properly secure the chain saw head may
result in personal injury and/or property damage.
m
WARNING!
Always ensure the chain saw head is
securely locked! Do not attempt to use the pole chain saw with
the head in any other position or unlocked!
Adjusting the Auxiliary Handle
The chain saw is equipped with an auxiliary handle that can be
adjusted and removed. Follow the instruction below to operate
the auxiliary handle
m
WARNING!
Make sure the knob, bolt, and the screws
are fixed into place. Failure to lock any of them as directed
could result in personal injury or property damage.
To Remove the Auxiliary Handle
1. Disconnect the saw from the power supply by removing
the battery from the compartment.
2. Unscrew the auxiliary handle lock knob and remove it and
the bolt, then the auxiliary handle can be pulled out
(Fig. 20).
Fig. 20
Bolt
13
Back Side
Rotating button
Auxiliary handle
Auxiliary handle
lock knob
