Idiomas disponibles
Idiomas disponibles
STEP 3:
PREPARE THE VENTING BLOWER
WALL VENTED
INSTALLATION:
1. Remove
two blower
unit mounting
screws
and one
blower
plate screw.
Remove
the blower
plate from
cabinet.
See Figure
12.
2. Carefully
lift the blower
unit out of the microwave
oven.
Disconnect
the blower
wire from connector.
See Figure
13.
3. Use side cutters
or tin snips
to cut and remove
knockouts
"B" from Back plate.
Discard
knockouts.
Be careful
not to distort
the plate.
See Figure
14.
4. Rotate
the unit so that the exhaust
ports face the rear
of the cabinet.
See Figure
15. Before
you insert
blower
unit, blower
wire must be like Figure
15.
5. Reassemble
the blower
wire into the connector.
6. Place
blower
unit back into cabinet.
Check that the
exhaust
ports face towards
the rear of the cabinet.
See Figure
16.
7. Reattach
the blower
plate to the top of the cabinet
as
it was originally
assembled.
Attach
with one blower
unit mounting
screw
and then one blower
plate
mounting
screw.
See Figure
17.
NOTE:
When
using wall venting,you
need one
blower
unit mounting
screw.See
Figure
17.
8. Go to STEP 4, PREPARE
THE WALL
AND
UPPER
CABINET
FOR INSTALLATION
located
on page
13.
blower unit
Knockouts "B"
connector
/
blower plate
back plate
_late
mounting screw
blower unit
mounting screw
Figure 12
blower wire
Figure 13
=
Parts "B"
Knockouts Parts "B"
Figure 14
exhaust
ports
Figure 16
blower
unit
Figure 15
_
lower plate
mounting
screw
blower unit
_
exhaust
blower unit
mounting screw
Figure 17
11
