Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
7
Install the Battery
• Make sure motor unit is unplugged.
• Using a Phillips head screwdriver, remove the battery cover on
the motor unit.
• Partially insert battery into motor unit with terminals facing
out.
• Oonnect the red (+) and black (-) wires from motor unit to
corresponding terminals on battery.
• Replacebattery cover.
ALWAYSwear protective gloves and eye protection when
changing the battery or working around the battery
compartment.
Battery
Battery Cover
INSTALLATION
STEP
8
Install the Lights
• Press the releasetabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
• Install up to a 100 watt maximum light bulb in each socket.
Light bulb size should be A19, standard neck only. The lights
will turn ON and remain lit for approximately 4-1/2 minutes
when power is connected. Then the lights will turn OFF.
• Reversethe procedure to close the lens.
• Use A19, standard neck garage door opener for replacement.
NOTE: Use only standard light bulbs. The use of short neck or
speciafity light bulbs may overheat the endpanel or light socket.
To prevent possible OVERHEATING of the endpanel or light
socket:
• DONOT use short neck or specialty light bulbs.
• DONOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DONOT use bulbs larger than IOOW.
• ONLY use A19 size bulbs.
1O0 Watt (Max)
-_,,
]
Standard Light Bulb
Release Tab
/
H
/
100 Watt (Max)
_
Lens
X
]
Standard
i _ k,,.
......
_
J
Light Bulb
'_:-
_,
.__9
18
