Setting Spool Pins; Presser Foot Lifter; Changing Presser Foot - Janome Hello Kitty hk15822 Manual De Instrucciones

q
q
e
e w
w
e
w
q
q
w
e

Setting Spool Pins

The spool pins are used for holding the
spools of thread when feeding the thread to
the machine.
To use, pull up the spool pins. Push down for
storage.
q Upper thread
w Hole
e Tangle
NOTE:
When using thread which has tendency to
tangle around a spool pin e, thread
through the hole w of spool pin as shown.
The hole should face the thread spool.

Presser Foot Lifter

The presser foot lifter raises and lowers the
presser foot.
You can raise it about 1/4˝ (0.6 cm) higher
than the normal up position to help place
heavy fabric under the foot.
q Presser foot lifter
w Normal up position
e Highest position

Changing Presser Foot

q Presser foot
w Groove
e Pin
CAUTION:
When attaching or removing presser foot,
turn OFF the power switch.
• To remove
Turn the handwheel toward you to raise the
needle bar to its highest position.
Raise the presser foot.
Push the toe of the presser foot q to snap
it off the foot holder.
• To attach
Place the presser foot so that the pin e on
the foot lines up directly below the
groove w of the foot holder.
Lower the foot holder to lock the foot in
place.
10