Idiomas disponibles
Idiomas disponibles
Activate the cursor N to release the venti-
lation grille and at the same time slide out
the grille (in the direction of the arrow) to
free it. The prefilter is located in the air out-
let area under the Hepa filter. Replace or
clean the prefilter by washing it with wa-
ter, then dry it and put it carefully back in
place. Refit the HEPA filter and ventilation
grid, sliding it in until you hear the cursor
click into place.
starting the carpet beater
To work, press the release pedal down and
lower the vacuum cleaner at the same time.
The carpet beater attachment will start up.
Avoid frequent use of the carpet beater at-
tachment on special rugs or carpets that
could become damaged over time.
english
carpet beater control
The carpet beater control device constantly
regulates the operation of the beater:
Green light: the carpet beater is working
correctly.
Red light: the carpet beater is locked or
it has been subjected to excessive stress.
Lift the base with the adjustment device
P, then move the appliance to the upright
position for a few seconds and resume
working. If the red light persists, switch
off the appliance, unplug it and check the
causes of blockage.
Red/Green light: the roller is not touching
the floor. Adjust the height of the base
using the dial P. It is possible that the roller
is worn or the transmission belt is broken.
Replace the roller or transmission belt.
16
