Idiomas disponibles
Idiomas disponibles
Your RoomAir
Conditioner
unit is designed to
be highly efficient and save energy. Follow these
recommendations
for greater efficiency.
1. Select thermostat
setting that suits your
comfort needs and leave the thermostat at
that chosen setting.
2. The air filter is very efficient in removing airborne
particles. Keep the air filter clean. Typically, filter
should be cleaned once a month. More
frequent
cleaning may be necessary
depending
on outdoor and indoor air quality.
3. Use drapes, curtains, or shades to keep direct
sunlight from heating your room, but DO NOT
obstruct the air conditioner.
Allow three (3) inches
around unit to circulate.
4. Start your air conditioner
before outdoor
air becomes
hot and uncomfortable.
This
avoids an initial period of discomfort while
the unit is cooling off the room.
5. When outdoor temperature
is cool
enough, use HIGH or LOW FAN
only. This circulates indoor air, providing
some cooling comfort, and utilizes less
electricity than when operating on a
cooling setting.
Your RoomAir Conditioner
was designed
for easy installation
in a single or double-hung
window. NOTE: This unit is NOT designed for
vertical (slider type) windows.
To avoid installation/operating
difficulties,
read the instructions
thoroughly.
NOTE:
Save the shipping carton and packing
materials for future storage or transport of the unit.
Please check the contents of the hardware
kit
against the corresponding
model check list, prior to
installation of the unit.
See lists below. (Fig. 1)
3/4"Screws
(12)
(_
1/4" Screws
(8)
(_
Top Channel(I)
factory installed
L Bracket(2)
Side Bracket(2)
(_
Seal(l)
(_
Foam(1 )
Side Curtain RH(1)
Side Curtain LH(1)
Fig.1
NOTE: Surplus
screw(s)
for spare use.
Tools Needed
for Window
Installation:
• Screw Drivers:
Both Phillips
and Flat Head
• Power Drill: 1/8 inch diameter
drill bit
• Pencil
• Measuring
Tape
• Scissors
• Carpenter's
Level
