Idiomas disponibles
Idiomas disponibles
REAR PANEL
35
35.- Power Switch
This switch controls turning on or off the power
36.- DC Input
DC 12-20V, 500mA Minimum
37.- MIDI THRU/OUT/IN
MIDI ports for connection to a sequencer or MIDI device
38.- DMX OUT
This connector sends your DMX value to the DMX fixture or DMX pack
39.- DMX Polarity Select
Used to select DMX polarity
40.- Audio Input
This jack accepts a line level audio input signal ranged from 100Mv to 1V pp
41.- Remote Input
Black Out and Full On may be controlled by a remote control using a standard 1/4" stereo jack.
OPERATIONS
1.- PROGRAMMING
1.1 Record Enable
1) Press and hold down the Record button
2) While holding down the Record button, tap the Flash buttons 1, 6, 6 and 8 in sequence
3) Release the Record button, the Record LED lights up, now you can begin programming your chase patterns
NOTA: The first time you turn on your unit, the default setting of the Record Code is Flash buttons 1, 6, 6 and 8.
You may change the Record Code to protect your programs
1.1 Security for Your Programs
To protect your programs from any editing by others, you may change the Record Code
1) Enter current Record Code (Flash buttons 1, 6, 6 and 8)
2) Press and hold down the Record and Edit buttons at a time
3) While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record Code
The Record Code consists of 4 Flash buttons(the same button or different buttons), be sure your new Record
Code consists of 4 Flash buttons
4) Enter your new Record Code a second time, all channel LEDs and scene LEDs will flash three time, now the
Record Code is changed
5) Exit Record mode. Tap the REC. EXIT button while pressing and holding down the Record button, release the
two buttons at a time, the Record mode is disengaged
18.
36
36
User Manual | TR-DMX48-2 by Triton Blue | June 2023 | www.triton-blue.com
38
39
40
41
