König Electronic Nano HomePlug Manual De Uso página 3

Bottom details
Ethernet port
Security / Reset button
1.3 Initial setup
The CS500PLCN100 is a Plug-and-Play device. You can easily use the device without any
complicated configurations and settings. You can also use the device to connect network devices like
computers and game consoles directly. You can also connect devices like Blu-Ray Disc™ player to a
router or modem for internet access.
Connect the HomePlug AV Ethernet Bridge to a computer or modem / router:
1. Plug one end of the Ethernet cable into an Ethernet port on the bottom of the HomePlug.
2. Plug the HomePlug into an AC wall power outlet near the device you want to connect to.
(Note: Do not plug this HomePlug into a power strip that has surge protection. Doing so will
degrade the power line performance. For best performance, plug the HomePlug directly into a wall
outlet.)
3. To connect to a computer, plug the other end of the Ethernet cable into an available Ethernet port
of your computer.
4. To connect to a modem / router, plug the other end of the Ethernet cable into an available Ethernet
port of your modem / router.
5. Make sure that the PLC link light is solid green.
6. Your HomePlug is now connected in the network.
Chapter 2: Individual HomePlug AV Network Setup (optional)
Since all HomePlug units do have a default security key, they will automatically be linked to all other
HomePlug units sharing the same electrical lines. If there are other HomePlug units in the building
(such as in an office or apartment building), you may want to create your own individual HomePlug
network group so that other HomePlug units cannot connect to your network. The section below
describes how to use the security button for reconfiguration in some situations.
2.1 Creating a new individual HomePlug AV Network (Network AB)
Two unassociated HomePlug units (A and B) are forming a network.
Security button
This function is designed to generate
an individual HomePlug network group
in a multi-node environment. Please
refer to the "Individual HomePlug
Network Setup" section below for
more details.
Reset button
This function is used to clear all data
and restore all settings to the factory
default values.
Note: The HomePlug must be plugged
in to restore all factory settings. Hold
the Reset button until the status light
begins to flash.
3