Craftsman 917.773707 Manual Del Usuario página 15

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
- See appropriate section in manual unless directed
PROBLEM
Does not start
to a Sears
Parts & Repair
Center.
CAUSE
1. Dirty air filter.
2. Out of fuel,
3. Stale fuel,
Loss of power
Poor trimming
performance
4. Water in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Throttle control lever not
in correct position
(if equipped).
1. Dirty air filter.
2. Buildup of grass, leaves,
and trash under trimmer.
3. Too much oil in engine.
4. Walking speed too fast.
CORRECTION
1. Clean/replace air filter.
2. Fill fuel tank.
3. Empty fuel tank and refill
with fresh, clean gasoline.
4. Empty fuel tank and refill
with fresh, clean gasoline.
5. Connect wire to spark plug.
6. Replace spark plug.
7. Move throttle lever to FAST
position.
1. Clean/replace air filter.
2. Clean underside of trimmer
and trimmer head.
3. Check oil level.
4. Trim at slower walking
speed.
Excessive
1. Lines uneven or broken.
1. Check trimmer lines.
Vibration
2. Loose nuts or bolts.
2. Check all hardware,
including engine bolts.
3. Damaged trimmer head.
3. Check/repair trimmer head.
Starter rope
1. Bent engine crankshaft.
1. Contact a Sears or other
hard to pull
qualified service center.
Lose of head
1. Belt not driving.
1. Put belt on pulleys or
drive
replace belt if broken.
Hard to push
1. Handle height position not
1. Adjust handle height
right for you.
to suit.
1. Trimmer line length is
too short.
Trimmer head
does not
retain line
2. Throttle control lever not
in correct position
(if equipped).
1. Trimmer line not
properly installed.
2. Broken line retainer clip.
3. Incorrect size of
trimmer line.
1. if line is worn or broken to
half of original length,
replace line.
2. Move throttle lever to FAST
position.
1. Follow instructions in
Maintenance section.
2. Replace string carrier plate
assembly.
3. Use .155 diameter
trimmer line.
15
loading