Idiomas disponibles
Idiomas disponibles
Operation
Pre-Operation Check
The engine is shipped without gasoline or oil in the engine. See
the Set-Up Section of this manual for instructions on adding oil
and gasoline.
Starting the Engine
WARNING!
Always keep hands and feet clear of
moving parts. Do not use a pressurized starting
fluid. Vapors are flammable.
NOTE:
Allow the engine to warm up for a few minutes after
starting. The engine will not develop full power until it reaches
operating temperatures.
NOTE: Do not pull the starter handle while the engine is running.
1.
Move throttle control to FAST (rabbit) position.
2.
Move choke to the ON position.
3.
Pull gently on the starter handle until it begins to
resist, then pull quickly and forcefully to overcome the
compression. Do not release the handle and allow it to
snap back. Return rope SLOWLY to original position. If
required, repeat this step.
4.
As the engine warms, slowly slide the choke control to OFF
position. If the engine stalls, restart engine and run with
choke at half-choke position for a short period of time, and
then slowly rotate the choke into OFF position.
Stopping the Engine
WARNING!
To avoid unsupervised engine
operation, never leave the engine unattended while
running. Turn the engine off after use.
Run engine for a few minutes before stopping to help dry off any
moisture on the engine.
1.
Move throttle control to STOP position.
2.
Wipe any moisture away from the controls on the engine.
5
9
