Idiomas disponibles
Idiomas disponibles
C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
C1. Adapting
microwave
blower for outside
Make
sure
thewires
are
not pinched.
back
exhaust
NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
1.
6.
Secure the blower
unit to the microwave
with
the screw.
Remove
and
save
screw
that
holds
blower
Plate
to
microwave.
Blower motor screw
2.
Lift
up the
Blower
Plate.
Blower
motor
of
Microwave
_%_
Back of
Microwave
Blower
motor
screw
Blower-Plate
From the Mounting
Plate
screw
3.
Carefully
pull out the blower
unit. The wires will extend
far
enough
to allow
you to adjust
the blower
unit.
BEFORE: Fan Blade Openings Facing
Forward
d B
End A
CAUTION:
Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the blower is
removed and re-installed.
4. Rotate blower unit counterclockwise 180° .
7. Attach
the exhaust adaptor
to the rear of the oven by
sliding it into the guides
at the top center
of the back
of the
oven.
Adaptor
_/
_
Back of
Gulde
From
Blower
motor
screw
(after
attached
the
exhaust
adaptor)
Push in securely until it is in the lower locking tabs. Take care
to assure that the damper hinge is installed so that it is at
the top and that the damper swings freely.
Before Rotation
After Rotation
\
I
Back of Microwave
Back of Microwave
C2. Mount the microwave
oven
see page
12-13
(proceed
on A1-A3)
5.
Place the blower
unit back
into the opening.
AFTER: Fan Blade Openings Facing
Back
End B
CAUTION:
Do not pull or stretch the blower unit wiring.
16
