Idiomas disponibles
Idiomas disponibles
FIG. 12
16. Connect Sensor wire from Swith and Paddle Assembly to Electronic Scorer (#14) as shown in FIG12 and 12A.
Connect the Adaptor (#34) to the Electronic Scorer (#14) as shown in FIGi2 and 12A.
Scorer
J
ete
™ Sensor wire
—
FIG. 13
17. Fold Position as below when you are not use the
basketball game and insert the Lock Pin(#33) as
ELECTRONIC
SCORER
OPERATION
shown in FIG. 13.
1. Plug in the Adaptor of the Electronic Scorer or Uns-
crew bolt using a screwdriver and open the battery
box. Insert 3 AA batteries ( not included) in the ord-
er of polarity as shown on the inside cover. Then cl-
ose the cover using a screwdriver. Turn the power
on using the on/off switch. (if the game will not be
used for a long period of the time, we recommend
that the batteries should be removed).
2. While game is in Sleep Mode, if a basketball is sco-
red, the game will turn back on and the score board
will begin the 5 sec. countdown.
3. After finishing the game, Turn
OFF the scorer by using the
ON/OFF switch. NOTE:
The scoreboard will turn
off after 5 minutes, if not
in use, however, we
recommend turning the
ON/OFF switch to OFF
when the game will not
be used for an extended
period of time.
Py
This device complies with the part 15 of the FCC rules.
Operation issubject to the following two conditions :
(1) This device maynot cause harmful interference, and
(2) This device must acceptany interference received, including interference that may
causeundesired operation.
