Idiomas disponibles
Idiomas disponibles
Transmitter Display Operation - The Pro881™ is designed to be the
most user friendly of any locator on the market which is why its
control panel differs from others'. Turn the transmitter ON by pressing
the power button. A good ground connection can be indicated by the
LED light in the top right corner of the panel underneath the active-
signal graphic. The brighter the light, the better the ground
connection. If the light does not turn on or is very dim you may
consider turning off the machine and moving your grounding stake to
a more suitable place for good ground connection. This tends to be a
moister surface rather than dry. You can also try getting the ground
wet and placing your stake into the ground again to try and improve
your connection. Select INDUCT, 33kHz, or 2 kHz mode. The
transmitter defaults to a 2 kHz signal which is a good general wire
locating choice. When tracking wires that are difficult to clip on to or
have hazardous voltages on them the INDUCT mode with the clamp
or internal broadcast antennas may be best. The 33 kHz signals are a
good alternative when the tracked wire is short or there are many
5
