Idiomas disponibles
Idiomas disponibles
10. COMMISSIONING OF THE DEVICE
The commissioning of the device requires the sending of configurations to the device via the Ethernet connection. For this purpose,
a PC equipped with a network card and connected to the COMPACT, either via a switch or directly via a network cable, is required.
The PC must have the Call Point or Call Point Configurator software installed on it.
1. Insert the battery (see section ¡Error! No se encuentra el origen de la referencia.) and insert the cards required for the installation
into the COMPACT (see section 6. INSERTING THE CARDS).
2. Make the connections between the devices.
3. Turn on the power supply to the devices.
4. Configure the parameters of the COMPACT matrix and the cards it contains using the Call Point or Call Point Configurator software
and send the settings to the device.
ATTENTION. In order to be able to send configurations to the device, it is necessary that the device and the PC are within
the same IP address range. It is also necessary that the network addresses of the device and those set from the
configuration software match.
By default, the device's network configurations are as follows:
IP ADDRESS:
NETMASK:
GATETEWAY: 0.0.0.0 (without Gateway)
If you wish to assign a different network address to the unit than the default one, follow the next section 10.1.
Configuration of the COMPACT network addresses
10.1. Configuration of the COMPACT network addresses
In order to be able to send configurations, the network addresses established from the configuration software and those of the unit
must match.
The network configurations of the unit may be modified directly from the front panel if an Administrator user access level is available.
To change the user, follow the section11.1. User levels and changes.
10.1.1. Changing the IP address
Use the / navigation keys to select the settings menu
1.
( ).
Using the / keys select IP (10.1.1.1) and press OK.
2.
Use the or keys to enter the desired digit (from 0 to
3.
9 and blank space).
Move to the next digit using the or navigation keys.
(for example, to enter number 24
enter a blank space, 2, 4)
4. To finish press OK.
COMPACT version 5.2.002 ENG
COMPACT
4ETH
10.1.1.1.1
255.0.0.0
10.1.2. Changing the Netmask
Use the / navigation keys to select the settings menu
1.
( ).
Using the / keys select NETMASK (255.0.0.0) and
2.
press OK.
Use the or keys to enter the desired digit (from 0 to
3.
9 and blank space).
Move to the next digit using the or navigation keys.
4.
To finish press OK.
10.1.3. Changing the Gateway
Use the / navigation keys to select the settings menu
1.
( ).
Using the / keys select GATEWAY (0.0.0.0) and press
2.
OK.
Use the or keys to enter the desired digit (from 0 to
3.
9 and blank space).
Move to the next digit using the or navigation keys.
4.
To finish press OK.
R + D Department
Modular audio matrix
with IP connection
19
