cecotec BOLERO SQUAD V 3001 Manual De Instrucciones página 54

ENGLISH
Timing of several cooking zones
- Each timer setting operation shall be the same as "Timing of a single cooking zone". As
long as a countdown time is set for the cooking zone, the corresponding indicator light for
that zone will flash.
- Press any cooking-zone selection icon, and the timer display will show the timer value for
that cooking zone.
- When no cooking zone is selected, the display will show the minimum timer value for all
zones.
9.2 Pre-set time
The 3 cooking zones have a pre-set timer function. If the timer is not set manually, the
pre-set timer and power level relation will be as follows:
Power level
Pre-set time
When all preset times are reached, the cooking zones will automatically switch off and enter
standby mode.
10. High temperature warning
- Press and hold the power icon manually for 3 seconds until it switches off. The whole
appliance will stop heating, but the cooking surface will still have a high temperature. The
display of the relevant cooking zone that has stopped heating will show the residual heat
warning symbol "H" to indicate the high temperature of the relevant cooking surface.
- Provided that the cooking zone has been heated up before, the corresponding indicator
light will continue to show "H" for 20 minutes after switching off.
11. Protection function
- Protection against high temperatures: When the hob temperature is too high, the
mechanical self-temperature limiting protection device will start, then the hob will stop
heating and will start heating again when the temperature drops.
- Protection against residual heat: When the whole appliance stops heating, the digital
tube of the relative heating zone will display the high temperature warning symbol,
indicating that the temperature of the cooking surface is too high. Please, do not touch to
avoid getting burnt.
- Safety shutdown protection: For plug-in models, when switched off after one second at
any time, the voltage between L/N of the plug must fall below the safe voltage range.
- Fault in the connection of the display board and the power supply board: When the
appliance is switched on, if the display board does not receive the correct signal from the
power supply board for 20 consecutive seconds, the 2-digit timer display will show "E1",
54
BOLERO SQUAD V 3001
1 2
6 hrs. 6 hrs.
3 4
5 hrs. 5 hrs.
5 6-9
1.5
4 hrs.
hrs.