Idiomas disponibles
Idiomas disponibles
5.4. Connecting the audio outputs
The equipment has two audio outputs through RCA connectors:
•
MUSIC output: audio output of the music channel.
•
PAGING/MUSIC output: Audio output of the paging channel. By
setting DIP switch 1 to ON, this paging output also becomes the
music channel output as long as no paging is sent.
Through the Call Point or Call Point Configurator software the volume
of each output can be adjusted. Maximum output level = 0dBm.
Follow figure 7 for connection.
MO2-700ETH
5.5. DIP switches configuration.
DIP switch 1 PAG-MUS.
In
OFF
position,
the
connector is used only as paging output
(PAGING).
In
ON
PAGING/MUSIC connector is used as paging
output and music output (PAGING/MUSIC).
Factory setting: OFF
DIPswitch 2 COM-GND
Connects (ON position) or disconnects (OFF
position) the COM contact of the terminal
strip to the GND of the device. Factory
setting: ON
5.6. Output Contacts
The unit has two output contacts:
-
MUS OUT CTRL is activated when the
music channel is active.
-
PAG OUT CTRL is activated when the
paging channel is active.
They are dry or grounded contacts, depending on the position of DIP switch number 2
(OFF= Dry contacts, ON= Grounded contacts).
ATTENTION: Max. DC load current: 150 mA.
Max. DC or AC peak load voltage: 350V.
MO2-700ETH 5.2.02 Version
MO2-700ETH
Figure 7
PAGING/MUSIC
position,
the
IP receiver with one music
output and one paging output
Figure 6
PAGING/MUSIC
OUTPUT
MUSIC
OUTPUT
Figure 8
Figure 9
Figure 10
R+D Department
DIP switches
configuration
9
