Hoover DXO4 H7A2TCEX-S Manual Del Usuario página 67

PAUSING THE MACHINE
l
Keep the START/PAUSE button pressed
for about 2 seconds (the name of the
programme and the residual time display
will flash, showing that the machine is
paused).
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, turn the
programme selector to the OFF position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
DELAY START button
l
This button allows to delay the start of the
programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
l
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION/RAPIDS
button
l
It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
l
The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly for 3 times.
l
If the programme selector is positioned on
the rapid programmes, the progressive
pressure of the key allows you to choose
the cycle time between: 30-45-59 minutes.
MEMO button
This button allows you to store the options
set on a cycle.
MEMORY:
when the cycle is running push the button
MEMO for 3 seconds. The writing MEMO
(all the digit on some models) will blink for 2
seconds and the options connected to the
cycle selected will be set.
RECALL:
after the selection of the cycle push the
button MEMO for recall the stored options
(not the cycle).
The delay start function can't be
memorized.
DRYING SELECTION button
l
This button allows to set the desired
dryness level editable option up to 5
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
67