Wall Bracket Assembly
1
Install the angle adjustment bracket on the wall as shown in
the figure.
2
4
6
Tighten the angle adjustment bracket by using anchors and
screwsⓐ orderly from ① to ⑦.
If it cannot be installed on the assigned area, install at the
nearest place.
Check the solidity of the wall before the installation. Strengthen the wall and install the bracket if the wall is not firm enough.
The supplied screws and anchors are for installing on concrete walls.
For the wall of plaster, marble, or steel, use the appropriate screws.
2
Securely fix the set to the wall. Pull the bracket forward and
unfold it. Insert the bracket to the assigned area of the angle
adjustment bracket and tighten the supplied 8 screwsⓑ.
(Same for both left and right side)
WMN4277SK_EU_IB-00_L21.indb
2
3
5
1
Screwⓐ 5EA
Screwⓐ 2EA
7
How to Tighten Anchors or Screwsⓐ
Make a hole in the wall with the drill of
6X50.
Clean up the hole.
Insert the supplied anchor to the hole.
Match the angle adjustment bracket to the
holes on the wall and tighten the screwsⓐ.
Use the drill with the required size when making a hole in
the wall. Be sure to follow the directions for the installation
to avoid safety problems.
Screwⓑ 4EA
Screwⓑ 4EA
2016-04-12
2:04:30
