During Assembly
Make sure
the
base
is
square by measuring
the diagonals and
level by using
a
spirit
level.
You
may
use
silicone lubricant spray
in
order to help you
slide
the panels into the profiles.
Do
not spray the polycarbonate
panels.
Use
a
rubber mallet if
necessary.
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and
assistance.
This icon
indicates
that the installer should
be
inside the product.
Attention
This
icon indicates
that
the installer should
be
outside the product.
During assembly
use
a
soft surface below the parts to avoid scratches and damages.
Steps
Step
5:
Make sure
the
base
is
square by measuring the diagonals and level by using
a
spirit
level.
(screws,
masonry anchors and spikes
are
not supplied)
Doors Assembly!
Doors
can be
installed
as
a
left or right hand doors
as
per
your decision.
These
instructions show
a
right
hand
door
assembly.
Step
7:
Determines
door direction.
Door post 987
is
where door hinges will
be
located.
Step 9:
Please
note the assembly
of
part #8549
as
shown
in
diagram
b.
Step
41:71g hten loose screws
in
the separating wall
as
shown
in
diagram
b.
Step 42:
Roof
window
can be
located on one
of the two
options.
Step 56:
In
case
the window doesn't closed properly,
please release
the
screws,
adjust the profile
and
tighten the
screw.
Step 57
:
Please
attach hinges
in
accordance
with your door direction
choise done
in
step
7.
* Please
tighten
all screws
when completing assembly.
.
Screws
411
and nuts
412
&
466
are used
throughout
the assembly
process.
.
Screws
411
are
to
be
assembled
from the outside and nuts
412 & 466
from the inside of the
greenhouse.
.
If
not specified otherwise, do not fasten
screws and nuts (411, 412
&
466)
more than
2-3
turns only.
Do
not
tighten them until completion of
the panels' assembly.
These
2
icons
indicate
if
screws'
tightening
is
required or not.
.
However,
in
some steps,
temporary tightening of
a
few
screws may be
needed to prevent
a
profile from falling.
Note:
Firmly connect the product to
a
level surface
immediately after completion of the
assembly.
Anchoring this product to the ground
is
essential to
its
stability
and rigidity.
It
is
required
to complete this
stage
in
order for your warranty to
be
valid.
