Idiomas disponibles
Idiomas disponibles
II__"hf;_ ml W:'Inl [ o_
HOW TO SET UP YOUR
UNIT
Location
of the Air Compressor
•
Locate the air compressor
in a
clean, dry, and well ventilated
area.
•
Locate the air compressor
at
least 12" away from the wall or
other obstructions
that will
interfere with the flow of air.
•
Locate the air compressor
as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electrical
wiring could cause power loss to
the motor.
•
The air filter must be kept clear
of obstructions
which could
reduce air flow to the air
compressor.
Anchoring
of the Air
Corn pressor
Excessive Vibration
can weaken the air
tank and cause an explosion. The
compressor must be properly
mounted.
The air compressor
MUST be bolted
to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete
anchors (not supplied)
4 - 5/8" Washer shims (found in
parts bag, if needed)
1.
Place the air compressor
on on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install
concrete anchors.
4.
Line-up holes in surface with
holes in air compressor feet.
5.
Place the (4) washers (not
supplied) between the floor and
air compressor feet. If needed,
solid shims may be placed
between the washers and floor to
evenly distribute
weight on all
four feet. See next figure.
3/8" Lag
..... I
Screw
............. I
(not
...................
_supplied)
5/8" Washer ....
_
I
(not suppliedi_.[
_
....................
I
ShimUn-_
Surface Line
Washer
_
Concrete Anchor
(not supplied)
(not supplied)
6.
Place the (4) 3/8" lag screws
through the air compressor feet,
washers, shims, and into the
anchors.
7.
Torque 3/8" lag screws to 7-10
ft.-Ibs.
11-ENG
D26625
