Poulan Pro PP2822 Manual De Instrucciones página 8

Ocultar thumbs Ver también para PP2822:
Idiomas disponibles

Idiomas disponibles

TOP SIDE
OF BLADE
CAUTION:
If the clearance
between
the
cutting
blades is set too wide, the blades will
not cut correctly.
If the blades are adjusted too
tight, overheating
may occur.
REPLACE
SPARK
PLUG
Replace spark
plug each year to ensure the
engine
starts
easier
and runs
better.
Set
spark plug gap at 0.025 inch (0.6 ram). Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pul! off spark
plug boot.
2. Remove spark plug from cylinder and dis-
card.
3. Replace
with
Champion
RCJ-6Y
spark
plug and tighten securely
with a 3/4 inch
(19 ram) socket
wrench.
4. Reinstall the spark
plug boot.
REPLACE
FUEL FILTER
To replace fuel filter, drain unit by running it dry
of fuel, then remove fuel cap/retainer assem-
bly from tank. Pull filter from tank and remove
itfrom the fuel line. Install new fuel filter on fuel
line; reinstall parts.
Fuel
Filter
mlWARNING:
Perform the following
steps after each use:
• Allow engine to cool, and secure the unit
before storing or transporting.
• Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
• Store unit with the blade cover installed.
Position unit so that any sharp object can-
not accidentally cause injury.
• Store unit and fuel well out of the reach of
children.
SEASONAL
STORAGE
Prepare unit for storage at end of season or if
it wil! not be used for 30 days or more.
If your unit is to be stored for a period of time:
• Clean the entire unit.
• Store in a clean dry area.
• Clean all parts and check for damage.
Have damaged parts repaired or replaced
by an authorized service dealer.
• Keep all nuts, bolts, and screws tight.
• Lightly oil external metal surfaces, includ-
ing the blade.
• Install the blade cover.
• Empty fuel tank before storage.
To oil the blade, do the following:
• Stop the engine and allow blade to come to
a complete stop.
• Ensure ON/OFF switch is in the OFF posi-
tion.
• Disconnect the spark plug wire.
• Apply a light machine oil along the edge of
the top strap as shown.
_,_
OIL
q
To0Stra0
FUEL
SYSTEM
Under
FUELING
ENGINE
in the OPERA-
TION section of this manual, see message
la-
beled IMPORTANT
regarding
the use of ga-
sohol in your engine.
Fuel stabilizer is an ac-
ceptable altemative
in minimizing the formation
of fuel gum deposits during storage. Add stabi-
lizer to gasoline in fuel tank or fuel storage con-
tainer. Follow the mix instructions found on sta-
bilizer container. Run engine at least 5 minutes
after adding stabilizer.
ENGINE
• Remove
spark plug and pour 1 teaspoon
of
40:1,2-cycle
engine oil (air cooled) through
the spark
plug
opening.
Slowly
pul! the
starter rope 8 to 10 times to distribute
oil.
-8-
loading