Idiomas disponibles
Idiomas disponibles
2. Delete a single programming on the receiver:
•
Press the „left" or „right" button on the remote control to select the
channel to be deleted (multi-channel system only). For 1-channel remote
control, go directly to the next step.
•
Press the programming button on the receiver 1x to switch to
programming mode. (the green LED flashes).
•
Press the „Down" button on the remote control within 10 SECONDS. The
green LED on the receiver flashes quickly for 1 second.
•
The program is deleted!
3. Delete all programming on the receiver:
•
Press and hold the programming button on the receiver for 3 sec.
(The green LED flashes quickly).
•
Within 10 seconds, press the programming button on the receiver again.
•
The green LED goes out.
•
All stored programs are deleted!
4. Reversing the direction of motor:
•
It may happen that the phases for the motor are connected the wrong
way round.
•
The screen goes up when you press the down button.
•
Instead of changing the wiring, the user can set the switch for the motor
rotation direction on the receiver to pos. 2 (default to Pos.1).
5. Switching the up/down buttons on the receiver:
•
It may happen that the receiver has been installed upside down and the
buttons are no longer located appropriately on the receiver.
•
Set the up/down key changeover switch on the receiver to Pos.2 to ch-
ange the function of the buttons (default is Pos.1).
•
Note: This setting has no influence on the remote control.
5
