Idiomas disponibles
Idiomas disponibles
5
5.1. Drill a pilot hole for the sliding door guide (O) using a ø1/8 in drill bit.
5.2. Install the sliding door guide (O) with the screw (CC) and the cap (II).
5.3. Place the support bar anchor (C) back on its wall mark, then mark its holes locations on the wall.
5.4-5.5. Drill a hole on the holes marks with a ø5/16 in drill bit . If there are no studs located behind the support bar anchor (C),
then insert the wall anchors (AA) using a rubber mallet until the wall anchors are flush with the wall. Fix the center fitting of the
support bar anchors (C) on the wall using the screws (GG).
5.1
ø1/8 in
5.4
ø5/16 in
C
A
RIGHT DOOR OPENING
FIXED PANEL AND SUPPORT BAR INSTALLATION
Add a drop of silicone in the
holes before inserting the
If there are no studs aligned to support bar
anchors behind the drywall, use the wall
anchors to ensure the screws won't become
C
O
5.2
II
CC
O
HELPFUL HINT!
screws.
WARNING!
loose.
C
GG
C
O
LEFT DOOR OPENING
5.3
5.5
C
AA
C
A
PAGE 16
