Shark HYDROVAC WD100 Serie Guia Del Usuario página 4

Limpiador 3-en-1 con cable
Idiomas disponibles

Idiomas disponibles

USING YOUR 3-IN-1 CLEANER
POWER ON
Press and release the Power button on the handle
to turn on power.
CLEANING MODES
HARD FLOOR MODE
Use Hard Floor mode for powerful cleaning on bare
floors. To activate Hard Floor mode, turn on the unit
and tilt the handle back.
NOTE: To prevent leakage, DO NOT place the main body on the floor. The nozzle should always be kept flat on the floor.
NOTE: If you encounter a difficult stain, use Area Rug mode for improved stain cleaning.
NOTE: If you encounter a stubborn odor on your floor or area rug, continue to clean in Area Rug mode until the odor is gone.
NOTE: If your floors are cloudy, streaky, or spotty after cleaning, it may be due to accumulated soap or grease residue. The
floor may require several cleanings with the Hydrovac.
s h a r kc l e a n . c o m
CONTROLS
POWER OFF
Press and release the Power button on the handle
to turn off power. Raise handle to upright position.
AREA RUG MODE
Area Rug mode always uses fluid and suction
simultaneously to optimally clean your rugs. To
switch to Area Rug mode, press the Area Rug icon
on top of the handle. The Area Rug light on the main
body will illuminate. Press the icon again to switch
back to Hard Floor mode.
MAINTAINING YOUR 3-IN-1 CLEANER
SELF-CLEAN CYCLE
The self-clean cycle automatically cleans the system and the brushroll.
Recommended after every use
RECOMMENDED AFTER EVERY USE
1.
Place the unit on the storage tray.
2.
Empty the Dirty Water Tank and make sure the
clean solution tank is at least half full.
3.
Press the Power Button to start the self-clean
cycle. The icon will pulse for the full 2-minute
duration of the cycle.
4.
DO NOT remove the unit from the storage tray
during the self-clean cycle. The icon will turn off
when the cycle is complete.
5.
Empty the dirty water tank.
NOTE: Make sure the clean solution tank is at least half full and that the dirty water tank is empty before running the self-
clean cycle.
NOTE: You will not be able to run a self-clean cycle until battery is sufficiently charged (1 solid bar or higher).
s h a r kc l e a n . c o m
loading