Hayter CODE102A Manual Del Operador página 13

Troubleshooting
Perform only the steps described in these instructions. All further inspection, maintenance, and repair
work must be performed by an authorised service centre or a similarly qualified specialist if you cannot
solve the problem yourself.
Problem
The battery pack loses
charge quickly.
The battery charger is not
working.
The LED indicator light on
the battery charger is red.
The LED indicator light on the
battery charger is blinking red.
The tool does not run or
does not run continuously.
Possible Cause
1. The battery pack is over or under
the appropriate temperature
range.
1. The battery charger is over
or under the appropriate
temperature range.
2. The outlet that the battery
charger is plugged into does not
have power.
1. The battery charger and/or
battery pack is over or under the
appropriate temperature range.
1. There is an error in the
communication between the
battery pack and the charger.
2. The battery pack is weak.
1. There is moisture on the leads of
the battery pack.
2. The battery is not fully installed
into the tool.
Corrective Action
1.
1.
2.
1.
1.
2.
1.
2.
13
Move the battery pack to a
place where it is dry and the
temperature is between 5°C
(41°F) and 40°C (104°F).
Unplug the battery charger and
move it to a place where it is dry
and the temperature is between
5°C (41°F) and 40°C (104°F).
Contact your licensed electrician
to repair the outlet.
Unplug the battery charger and
move the battery charger and
battery pack to a place where
it is dry and the temperature is
between 5°C (41°F) and 40°C
(104°F).
Remove the battery pack from
the battery charger, unplug the
battery charger from the outlet,
and wait 10 seconds. Plug the
battery charger into the outlet
again and place the battery pack
on the battery charger. If the LED
indicator light on the battery
charger is still blinking red, repeat
this procedure again. If the LED
indicator light on the battery
charger is still blinking red after 2
attempts, properly dispose of the
battery pack at a battery recycling
facility.
Properly dispose of the battery
pack at a battery recycling facility.
Allow the battery pack to dry or
wipe it dry.
Remove and then replace the
battery into the tool making
sure that it is fully installed and
latched.
EN