Charging The Battery Pack - Hayter CODE102A Manual Del Operador

Operation

Charging the Battery Pack

Important: The battery pack is not fully charged when you purchase it. Before using the tool for
the first time, place the battery pack in the charger and charge it until the LED display indicates the
battery pack is fully charged. Read all safety precautions.
Important: Charge the battery pack only in temperatures that are within the appropriate range; refer
to Specifications.
Note: At any time, press the battery-charge-indicator button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger are clear of any dust and debris.
2. Line up the cavity in the battery pack with the tongue on the charger Figure 5.
3. Slide the battery pack into the charger until it is fully seated Figure 5.
4. To remove the battery pack, slide the battery backward out of the charger.
5. Refer to the following table to interpret the LED indicator light on the battery charger.
Indicator light
Off
Green blinking
Green
Red
Red blinking
*Refer to Troubleshooting for more information.
Important: The battery can be left on the charger for short periods between uses.
If the battery will not be used for longer periods, remove the battery from the charger; refer to
Storage.
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is charged
Battery pack and/or battery charger is over or under the appropriate temperature range
Battery pack charging fault*
Figure 5
11
EN