Idiomas disponibles
Idiomas disponibles
16
XTM1-35 VOCAL SET
XTM1-35 VOCAL SET Getting started
(EN) Step 3: Getting
started
OVERVIEW
This 'getting started' guide will help you set up the
XTM1-35 VOCAL SET microphones and receiver.
CONNECTION
To connect the XTM1-35 VOCAL SET to your system,
please consult the connection guide earlier in
this document.
INITIAL SETTING UP
1.
Position the receiver at a minimum height
of 1 m and point the antennas upwards for
optimal signal transmission.
2.
Make sure that antennas do not touch or
cross if multiple wireless systems are used
in an installation.
3.
Do not position the receiver in the direct
vicinity of metal objects and digitally
controlled devices (media players, computers,
digital consoles, etc.).
4.
The microphone and receiver should be within
direct "line of sight" of each other.
5.
Connect the receiver's output to your audio
system, using either the balanced XLR or
unbalanced TS outputs.
6.
Select the receiver's MIC/LINE switch. To send
line-level audio to your sound system, select
LINE. To send microphone-level audio, select
MIC.
7.
Adjust the VOLUME control to minimum.
RECEIVER SETUP
Power on/off
1.
Press the power button to power on or off the
receiver.
Main Menu
2.
The channel frequency (FREQ), channel
number (CH), signal level (RF), audio level
(AF), Squelch (SQ) are displayed in the main
receiver menu.
Selecting a Frequency Channel
3.
Press SET key repeatedly until CH number
flashes in the receiver display. Press CH+/CH-
to select the desired frequency channel (see
frequency chart).
NOTE: For simultaneous operation of several
systems, please make sure that all the systems
use different frequency channels.
Standby Mode
4.
The receiver unit will go into standby mode
if signal reception is not detected for 20
minutes. Press the power button to return the
receiver unit to working mode.
Squelch (SQ)
5.
The Squelch function enables you to set a
minimum threshold of signal received by the
receiver. The setting consists of 3 bar levels –
Low (1), Medium (2), and High (3). The receiver
rejects signals below the set threshold and
helps eradicate any unwanted audio signal
transmitted by the transmitter.
6.
Press the SET button repeatedly until "SQ"
flashes in the receiver display. Use the CH+/
CH- buttons to set Squelch level at 1, 2, or 3.
MICROPHONE SETUP
Batteries
1.
Unscrew the lower sleeve of the microphone
to access the battery compartment.
2.
Insert two new and identical AA batteries,
observing the correct polarity.
3.
Screw the lower sleeve back on to close the
battery compartment.
Power on/off
4.
Press and hold the power button to power on
or off the microphone.
Mute on/off
5.
Slide the switch to mute or unmute the
microphone. The LED is Red for Mute, and
Green for unmuted.
