Idiomas disponibles
Idiomas disponibles
o
o
o
o
o
an audible click will be heard.
NOTE: The head will only rotate in one direction.
NOTE: The Auto Feed System may not operate correctly if
edge guide is not used.
Remove the battery from the tool.
Press and hold the head release button (J1).
While holding the auxiliary handle, rotate the head counterclockwise.
Release the head release button.
Drop the edge guide (J2) in to the open position. Ensure that the edging guide is all the way down,
SWITCHING
ON AND OFF
• To switch the tool on, press in and hold the lock off button
(K1) then squeeze the trigger lever (K2). Once the tool is
running you may release the lock off button (K1).
• To switch the tool off, release the trigger lever.
AWARNING:
Never attempt to lock the trigger lever in
the on position.
POWER
COMMAND
= MAX POWER / MAX RUNTIME
The max power / max runtime feature (L1) is located on the
tool handle. It allows you to optimize the tools performance
and boost the power as needed.
• To choose max power to tackle thick weeds, rotate dial to
setting 6.
• To choose max runtime to increase battery life rotate dial to
setting 1.
• For a combination of both, rotate dial to setting from 2 to 5.
OPERATING
THE TRIMMER
• With the unit on, angle unit and slowly swing the trimmer side to side as shown in figure M.
• Maintain a cutting angle of 5° to 10 ° as shown in figure M1. Do not exceed 10°(figure M2). Cut
with the tip of the line. To keep distance from hard surfaces use edge guide (10). Pull the guide out
until it snaps securely into place
• Maintain a minimum distance of 24 inches (609.6 ram) between the guard and your feet as shown
in figure M3. To acheive this distance adjust the overall height of the trimmer as shown in figure
H.
/'_J
_ ......
i/' \'\ '_/
{
lO
24 inche
(609.6 ram)
