Idiomas disponibles
Idiomas disponibles
CANISTER
1. Open the canister
hood
2. Check to see that the dust bag is proper-
lyinstalled. See BAG CHANGING
for
instructions.
3. Check to see that the motor safety filter is
properly installed, See MOTOR SAFETY
FILTER CHANGING
for instructions
HOOD AND TOOL
STORAGE COVER
It is normal for the canister
hood and tool
storage cover to come off when opened fur-
ther than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and toot storage cover to reinstall,,
i
kCAUTION
Never open canister
hood with the tool
storage
cover open.
This will help to
prevent
damage
from occurring
to the
canister
hood and/or
toot storage
cover.
HOSE
1. Line up the hose
latch tab and notch
in canister
hood
and insert hose
into canister until it
snaps in place
To remove:
Lift
hose latch tab
upward and pull up
on hose,
Hose
Latch
Tab
Notch
Lock
2. Insert handle
into wand until
lock button
snaps in place,
Be sure hose
is not twisted,
m
=a
To remove:
Handle
Quick
Press handle
Release_,,.,._
quick release
button and pull
up on handle,
To store:
Disconnect
hose from wands and
canister to prevent stress on hose during
storage,
Store hose in a loosely coiled
position so the hose covering is not
stressed,
This canister is equipped with an on-board
storage area for a Power-Mate
,Jr, e
attachment°
To Install:
Open the Power-Mate
Jr2 storage cover,
insert the Power-Mate
Jr, e, press down into
place, and close the lid securely,
To Remove:
Open the storage cover.
Remove Power-
Mate Jr.® from the storage area and use as
needed (see ATTACHMENTS
and
ATTACHMENT
USE TABLE).
Power-Mate Jr, ®
Storage Cover
/
