Idiomas disponibles
Idiomas disponibles
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is chart eg__d
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner
Use
Clea__l__n_A_itator
HEAVY -
every week
(used daily)
MODERATE
-
every month
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
every 2 months
IMPORTANT
Disconnect
vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently
in the
Power-Mate ® agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps,
AGITATOR ASSEMBLY
Belt Pulley
q
"-..Tj,-r "_
/
Cap
Brush
Unit
TO REPLACE
BELT
1. Install new
belt over
motor drive,
then over
belt pulley
r
Agitator
End Cap
NOTE: See PARTS AND FEATURES
for
Belt number.
2. Place agitator
assembly
back into
Power-Mate e
3. Line up
./__J_"!"_///'_"
front of
cover and
baseoRest
_
_(_I_
!)!_
cover on
front edge
"%Z'Z.Z_.z-z_
_!!!_;
of base as
! er
!i il_;!_
';--'__,,_-,,
_
shown.
': ::-="; _ "
Co
Base
;_?!_
4, NOTE: On dirt sensor models be sure
_t'_;:::_.::;
that the board is upright and the wires are
tucked back in place.
]
5. Rotata cover
back. Press
cover firmly until
"
side and rear
,, ,! - "_
tabs snap into
.... -_ ._
place,
Make sure there
Side
Rear
Latch
Latches
is no gap
between the cover and base
6. Turn Power-Mate®upside down and
replace two (2) cover screws,
19
