GE 21 Manual Del Propietario E Instalación página 21

Removingand replacing the doors.
When installing or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator
through a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator is
unplugged.
0 Disconnect water line and wiring harness.
Near tile lower hinge on tile fl'eezer side, push in on the
colla_ at each end of tile coupling, and pull tile water
line robing fl'onl tile coupling. _Mso, disconnect wi_ing
harness. Pull tile water line and tile harness through tile
h)wer rail.
0 Remove the hinge covers and the hinges.
In order to access tile hinges, tile hinge cox'e_ need to be
removed. Remove
tile cover bv grasping
it on tile sides,
near the back of the cove_: Push back on the cover and
lift up at the back, then the fl'ont.
/VOTE:DO NOTuse a screwdriver to remove the cover BECAREFUL
not to break the rear retaining tab on the hinge cover Removethe
hinges uslbg a TorxT-20.
Remove the doors.
Careflfllv rotate tile door to 90_ Guiding tile disconnected
water line and wi_ing harness, lift tile door smfight up.
NOTE: Not lifting the door straight up may damage the bottom hinge.
P/acedoors on a protectedsufface.
NOTE: Be careful not to pinch the water tubing and the wire harness
at the bottom of the door
NOTE: Donot allow the connector to contact the floor Hardcontact
can damage the connector See "Rep/aclbgthe Doors."
Replacing the Doors
Place doors on bottom hinges.
O _'_ith tile door at 90_' lower tile door straight down onto
tile bottom hinge. Careflfllv close tile do(n:
NOTE: Not lowering the door straight down onto the bottom hinge
may damage the hinge.
/VOTE:Donot allow the connector to contact the floor Hardcontact
can damage the connector See "Replacingthe Doors."
Replace top hinges and hinge covers.
Reinstall tile top hinges using a Torx T-20. Replace tile
hinge cove_s. If the doo_s are not level, ac!iust the bottom
_ight hinge with a 7/] 6" open ended wrench.
Reconnect water line and wiring harness.
Insert water tubing back into coupling, making sure tile
tubing is pushed Ira" enough into tile coupling so that you
no hmger see the mark on the tubing. Reconnect the
wi_ing harness.
Turnon the water supply and plug the refrigerator back in.
......
WireHaines%
\
_Hinge Cover
I ' _ Door
_"'_ Hinge Pin
Connect0r
2/