Idiomas disponibles
Idiomas disponibles
How To Use the Adjustable
Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
_
CAUTION!
Never adjust spray pattern when
spraying. Never put hands in front of nozzle to
adjust spray pattern.
On the end of your spray gun is an adjustable nozzle
that you can use to adjust the spray pattern and the
spray pressure.
•
Slide the nozzle forward for low pressure spray;
slide it backward for high pressure spray.
•
For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning
surface.
•
If you get the spray nozzle too close, especially
using high pressure mode, you may damage the
surface being cleaned.
•
Do Not get closer than 8 inches when cleaning
tires.
Applying
Detergent
with the Adjustable
Nozzle
IMPORTANT:
Use chemicals designed specifically
for pressure washers, Household detergents could
damage the pump.
IMPORTANT:
You MUST attach all hoses before you
start the engine. Starting the engine without all the
hoses connected and without the water turned ON will
damage the pump.
To apply detergent, follow these steps:
•
Review the use of the adjustable nozzle.
•
Prepare detergent solution as required by the job.
•
Hang the detergent solution container on the hook
attached to the handle.
Slide nozzle backward for
Slide nozzle forward for
high pressure mode.
low pressure mode and
detergent application.
•
Point the nozzle towards a hard surface, disengage
the safety latch, and press the trigger to test the
pattern.
Rotating the nozzle adjusts the spray pattern from
a narrow pattern to a fan pattern.
Twist nozzle counter-
clockwise for fan pattern.
Twist nozzle clockwise for
narrow spray pattern.
•
Place the filter end of the detergent siphoning tube
into the detergent container.
CAUTION!
When inserting the filter into the detergent
container, route the tube so as to keep it from
inadvertently contacting the hot muffler.
•
Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle
in high pressure position.
•
Make sure the garden hose is connected to the
water inlet. Check that the high pressure hose is
connected to the spray gun and the pump. Start
the engine.
•
Apply detergent to a dry surface, starting from the
bottom and working up.
•
Allow the detergent to "soak in" for 3-5 minutes
before rinsing. Reapply as needed to keep the
surface wet.
•
For washing, start at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
