SETUP
• Connect the 10 ft. USB cable by plugging it into any available USB port on your Xbox console.
• Connect the other end to the USB-C port on your PowerA Advantage Wired Controller with Lumectra.
• Hold down the Xbox Button until your console powers "ON". The controller's Connection / Program
LED will illuminate to indicate your controller is connected.
INTERNAL LEDS - PROGRAM FUNCTION
The controller has 4 separate lighted Lumectra Zones that you can customize:
Zone 1
Zone 2
1. To enter LED Program Mode on the controller, hold the INT
LED button on the back of the controller for 2 seconds.
The Program / Connection LED will blink slowly while the
controller is in LED Program Mode.
2. The current programmable Zone will flash 3 times. To
toggle through the 4 Zones, press "Right" on the D-Pad.
(Zone One is the default starting zone.)
3. Select one of the A/B/X/Y buttons to choose your color: green, red, blue, or yellow.
4. Next, continue pressing the selected A/B/X/Y button to toggle through 6 shades of that color.
5. Press "Left" on the D-Pad to program the zone's light effect: "Solid", "Breathing", or "Cycle".
6. Press "UP" and "DOWN" on the D-Pad to adjust that zone's brightness level.
Zone 3
Zone 4
7. In program mode, press "INT LED" once to turn off the current zone independently of the other
zones. If the current zone is set to "off", press "INT LED" once to turn the zone back on. NOTE:
Outside of program mode, pressing "INT LED" once will turn all LEDs on or off.
8. Press the "View" button to toggle through multiple speed settings for the current zone. Press the
Menu button to toggle through multiple speed settings for all 4 zones simultaneously.
NOTE: This feature is only available in "Breathing" and "Cycle" modes.
9. While in program mode, press LB to sync all zones to the same lighting mode and toggle all zones
through the 3 lighting modes simultaneously; press RB to sync all zones to the same color and
toggle all zones through the 24 colors and shades simultaneously. .
10. While in program mode, press LT to decrease the brightness of all zones simultaneously; press RT
to increase the brightness of all zones simultaneously.
11. While in program mode, hold "INT LED" for 2 seconds to save any changes made to light settings.
All 4 LED zones will flash 3 times to indicate the controller is now out of LED program mode. NOTE:
The controller will store the 2 most recently saved LED light settings.
12. Outside program mode, double press "INT LED" quickly to toggle between the 2 most recently
saved light settings.
13. Outside program mode, press "INT LED" once to turn all LEDs on or off. The LEDs will display the
most recently used selection of saved settings.
