cecotec CONGA ROCKSTAR 6500 CENTURY ERGOWET ANIMAL Manual De Instrucciones página 58

ENGLISH
Emptying the dust tank. Fig. 10
Place the dust tank from the main body over a bin.
-
Push the black tab located on the lower part of the dust tank until the cover opens.
-
Then, dust will fall off, so you must secure the tank is in the bin position.
-
Filter cleaning and maintenance. Fig. 11
It is recommended to clean the filters regularly to ensure maximum efficiency.
-
Pull the dust tank release trigger and separate the dust tank from the upright vacuum
-
cleaner.
Remove the primary filter and the pre-filter assembly.
-
Disassemble the pre-filter assembly by turning the mesh filter clockwise and pulling.
-
Vacuum and shake the filters to remove every particle and dust remain that may block it
-
and make air circulation difficult.. Remember not to use the vacuum cleaner without the
filters properly assembled.
Do not brush the filters.
-
Cleaning the brushes
It is important to clean the brushes regularly to avoid hair and other foreign objects from
tangling and to prevent blockages. Fig. 12
Fig. 13
Press the brush release button on the bottom part of the brush head and remove the
-
brush.
Remove the brush side tab.
-
Remove the Jalisco brush from the vacuum cleaner brush head.
-
In order to avoid any damages in the brush, hair can be cut and removed if it is wrapped
-
around both sides of the Jalisco brush.
You can clean the Jalisco brush with warm water, do not use soap or detergents.
-
However, it is recommended to shake it or vacuum it to avoid placing it back again wet in
the brush head.
If you decide to wash the Jalisco brush, make sure it is completely dry before installing it
-
again on the device.
Make sure it is properly installed, otherwise the brush will not start operating.
-
58