Bosch Nexxt 800 Serie Operacion, Cuidado E Instrucciones Para La Instalacion página 20

4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
5. Insert the filter.
6. Close the door.
Cleaning the exhaust duct
Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
can lengthen the drying time.
Turn off the circuit breaker
Pull out power supply plug
Disconnect the duct from the
dryer.
Vacuum and reconnect the duct.
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only!
Clean the moisture sensor once a
month.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
Change the light bulb
The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
Set program selector to "Off".
I urn off the circuit breaker.
Pull out power supply plug.
Open the door and locate the light
bulb on the upper left side of the
seal.
Loosen the screw of the cover and
open the cover.
Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
Replace the cover and secure with
the screw.
Plug in dryer or reconnect power
supply.
2O