Idiomas disponibles
Idiomas disponibles
GENERAL ASSEMBLY INSTRUCTIONS
Safety glasses and a flathead screwdriver is required.
1
6
CASTER SYSTEM ASSEMBLY
1. You will find four caster feet FIGURE 1, four casters FIGURE 2, and four
screws with your wet/dry vacuum.
Assemble as follows:
2. With cord disconnected from receptacle and tank cover removed, turn tank
upside down so that the bottom is facing up.
3. With tank drain facing you, take caster feet marked with letter A and place in
slots on left front and right rear of tank also marked with the letter A.
FIGURE 3.
4. Secure with screws provided. FIGURE 4.
5. Take caster feet marked with the letter B and place on right front and left rear
of tank also marked with the letter B FIGURE 5.
6. Secure with screws provided FIGURE 6.
7. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. FIGURE 7.
8. Return tank to upright position.
TOOL HOLDER ASSEMBLY
9. With rear of unit facing you, take tool holder and position it with tabs facing
rear of unit. FIGURE 8.
10. Place "J" shaped tabs into the slots on cord wraps FIGURE 9. Press down
until tabs snap into place.
11. Press down on center of tool holder until tab latches on bottom of lid.
FIGURE 10.
2
7
3
A
A
A
A
8
4
B
9
5
B
B
10
5
