Assembly - gc Labolight DUO Instrucciones De Uso

4.4 Assembly

1) Pull the door slowly and rotationally upward by holding the handle.
2) Set the turntable in alignment with the turntable shaft.
* Six aligning positions are provided at an interval of 60 degrees where
the turntable can be pushed deeply to the bottom. Select one of the six
positions.
3) Set a tray in the concave provided on the top surface of the turntable.
■ When opening / closing the door, do not allow your hand or part of your
body or the object to enter into below the door or the gap. Otherwise,
personal injury or property damage could be caused.
4) Connect the power cord to the AC adapter.
5) Connect the DC plug of the AC adapter to the power connector located on
the rear surface of the main body.
6) Connect the power cord to the 3P outlet(100-240 AC).
* see Chapter 10 ,"Specifi cations".
7) Verify that the power indicator is lit on the AC adapter.
" If unlit, recheck the connections
■ Be sure to provide grounding when connecting the power plug.
■ Pay attention to the power source in terms of its frequency, voltage, and allowable current (or power
consumption).
■ Use the attached dedicated power cord and AC adapter.
● Only use genuine parts and accessories. Using other than genuine parts and accessories will cause
termination of warranty and no more liability from GC.
CAUTION
7
CAUTION
9
CAUTION
Note
11
7
8
9
10
11
12
EN 13