Idiomas disponibles
Idiomas disponibles
5
Installation Of Appliance
Hold the cooker hood by its body and place it
on the mounting screws on the wall and tight-
en the screws (Figure 9).
Secure the cooker hood with a 5.5x60 screw
to the wall through the mounting hole on the
interior of the appliance (Figure 9).
5.4 Connecting to Chimney
If you are going to use the Ø 120/150 mm
plastic Chimney adapter, connect one end of
the pipe to this adapter, if you are not going
to use it, to the direct output on the product.
Connect the other end of the pipe to your
Chimney . Check that these two connections
are tight enough so they will not come out
when the appliance runs on full power. Check
if the flaps inside the Chimney operate when
they are tightened
with clamps. Connect the Chimney con-
nection duct outside the adapter (Figure 11
/a). If the connection duct is fitted inside the
adapter, suction of air shall not occur as the
Chimney flap that prevents the return of air
will remain closed (Figure 11 / b). The length
of the pipe connection as well as the number
of elbows must be as minimum as possible.
A : Chimney exit pipe
B : Non return flaps
C: Plastic flue
The valves are closed then the appliance is
not operating and prevent possible outside
odour and dust from entering inside.
(Figure 10)
Cooker Hood / User Manual
(a)
Ok
(Figure 11)
5.5 Installation of the Hood to the
Chimney
Make the electrical connection of your hood
before starting the installation of the Chimney
. Slip the Chimney plates around the body.
Install the Chimney plate to the Chimney fas-
tening plate that is secured to the wall from its
upper outer edges (Figure 12).
(Figure 12)
1. Inner Chimney
2. 3.5x9.5 Screw
3. Chimney Connection Plate
(b)
Not Ok
13 / EN
