Idiomas disponibles
Idiomas disponibles
JUNCTION BOX WALL MOUNT
Use a large Phillips or
4
flat-head screwdriver to
remove the 1/2" threaded
KO plug from the back
plate.
Secure the main body to
8
the octagonal junction box
with screws. The main body
has an integrated bubble
level to assist with leveling.
CONDUIT WALL MOUNT
Drill mounting holes
4
through each of four corner
mounting locations.
Level the main body and
8
secure it to the wall with
screws.
2
©2022 EiKO Global, LLC. World Headquarters: 18000 W. 105
Drill holes through the
5
back plate to match the
junction box mounting
screws required.
Connect fixture to the
9
power supply as per the
included wiring diagram.
Using the drilled out main
5
body as a template, mark
level and drill holes in the
location the fixture will be
mounted.
Connect the conduit to the
9
desired 1/2" KO. Wire the
fixture per the provided
wiring diagram.
Head Office, Canada: 80-86 Carrier Drive Toronto, ON Canada M9W 5R1 (P) 1.888.741.2673 (F) 1.888.705.1335
Remove the foam plugs
6
from the pad to allow the
screws to pass through
the pad and into the
junction box.
Hook the cover of the fixture
10
back onto the hinge of the
main body.
Install anchors into the
6
drilled holes.
Hook the cover of the fixture
10
back onto the hinge of the
main body.
Street, 3
Floor, Olathe, KS 66061 (P) 1.800.852.2217 (F) 1.800.492.8975
th
rd
Thread the wire through
7
the back plate plug hole.
Ensuring uniform gasket
11
coverage, close the cover
and tighten screws to com-
plete installation.
Remove an available 1/2" threaded
7
KO plug to run conduit to the
fixture. Peel and adhere the 4
circular foam pads to the back of
the main body.
Ensuring uniform gasket
11
coverage, close the cover
and tighten screws to com-
plete installation.
eiko.com
Rev. 12/06/22
