Idiomas disponibles
Idiomas disponibles
Tighten adjust nut
B to raise mower
Loosen adjust
nut B to lower
mower
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut will change
mower height about 1/8".
• Recheck
measurements,
adjust if nec-
essary
until front tip of blade is 1/8" to
1/2" lower than the rear tip,
• Hold adjustment
nut in position
with
wrench
and tighten jam nut securely
against adjustment
nut,
To Replace
Mower
Drive Belt
MOWER
DRIVE
BELT REMOVAL
1,
Park
tractor
on
a
level
surface.
Engage
parking
brake_
2,
Lower
attachment
lift lever
to
its
lowest
position,
4,
Remove
any dirt or grass
clippings
which
may
have
accumulated
around
mandrels
and entire
upper
deck
surface,
5,
Remove
beltfrom
clutch
pulley
(M),
both mandrel
pulleys (R)
and all idler
pulleys
(S).
MOWER
DRIVE
BELT INSTALLATION
1,
Install
belt
around
both
mandrel
pulleys
(R) and around
idler pulleys
(S) as shown.
2,
Install
belt
onto
clutch
pulley
(M).
IMPORTANT:
Check
belt for proper
routing in al! mower pulley grooves.
3_
Raise attachment
lift lever to highest
position°
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor on level surface,
Engage
parking
brake,
For assistance,
there is a
belt installation
guide decal on bottom
side
of left footrest,
BELT REMOVAL
I
Remove
mower
(See "TO REMOVE
MOWER"
in this section
of manual).
NOTE:
Observe
entire motion drive belt
and position
of all belt guides
and keepers,
2,
Remove
belt from stationary
idler (A)
and clutching
idler (B),
3.
Remove
belt from centerspan
idler (C)o
6_ Pull belt slack toward
rear of tractor,
Carefully
remove
belt upwards
from
transmission
input pulley and over
cooling fan blades
(D),
4,
Remove
belt downward
from engine
pulley (E),
5,
Slide belt toward
rear of tractor,
off the
steering
plate (F) and remove
from
tractor.
BELT INSTALLATION
-
1, Install new belt from tractor
rear to
front, over the steering
plate (F) and
above clutch
brake pedal shaft (G).
2
Pull belt toward
front of tractor
and roit
belt onto engine pulley
(E).
3, Pull belt toward
rear of tractor, Care-
fully work belt down around transmis-
sion cooling
fan and onto the input
pulley
(D), Be sure belt is inside the
belt keeper_
4,
Install belt on centerspan
idler (C),
5,
install belt through
stationary
idler (A)
and clutching
idler (B).
6.
Make sure belt is in all pulley grooves
and inside all belt guides
and keepers.
7,
Install mower
(See "TO INSTALL
MOWER"
in this section
of manual),
24
