Idiomas disponibles
Idiomas disponibles
ConnectHosesand Water Supply
NOTICE Use ONLYcold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2. Run water through garden hose for 30 seconds to flush
the hose of debris. Turn off water.
3. Confirm that water inlet screen (A) is installed in water
inlet located at lower front of unit; Do Not remove except
for cleaning.
.
Attach opposite end of high pressure hose to the spray
gun. Press red button (F) on spray gun, then insert end
of high pressure hose (6) into gun until it SNAPSinto
place. Releasethe red button and make sure connection
is secure.
ConnectWand and Spray Tips
1. Turn ONwater, point gun in a safe direction, press trigger
release(H), then squeezetrigger (J) to purge pump
system and spray gun of air and impurities.
NOTICE If inlet screen is damaged or missing, DONOT
use electric pressure washer. Call 1-800-222-3136 for
assistance.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
.
5.
•
Damageto equipment resulting from failure to follow
this instruction will void warranty.
Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
Attach high pressure hose (D) to the unit's water outlet
(E) located at lower back of unit. Tighten by hand.
/
/
/
i
/
/
2. insert and twist wand (1() into spray gun (IVi).Once wand
slides into gun, apply further inward pressure to wand
and twist 1/4 turn clockwise until securely in place.
3. When the metal wand is installed, select the spray tip you
want to use. Pull back on collar of wand (N), insert spray
tip (P) and releasecollar. Tug on spray tip to make sure it
is securely in place. See How to Use Spray Tips.
4. Turn OFFwater and releasetrigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.
