HP Latex 2700 Serie Información De Introducción página 7

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
To avoid the risk of burns, take the following precautions:
Do not touch the internal enclosures of the printer's drying and curing modules.
Take special care when accessing the substrate path.
Take special care with zones marked with warning labels.
Do not place objects covering LED array supports, beam, and enclosures.
Do not attempt to modify LED array supports, beam, and enclosures.
Remember to let the printer cool down before performing some maintenance
operations.
Fire hazard
The drying and curing subsystems of the printer operate at high temperatures. Call your
service representative if the printer's built-in Residual Current Circuit Breaker (Ground Fault
Circuit Interrupter) is repeatedly tripped.
To avoid the risk of fire, take the following precautions:
Use the power supply voltage specified on the nameplate.
Connect the power cords to dedicated lines, each protected by a branch circuit
breaker according to the information detailed in the site preparation guide.
Do not insert objects through slots in the printer.
Take care not to spill liquid on the printer. After cleaning, make sure all components
are dry before using the printer again.
Do not use aerosol products that contain flammable gases inside or around the
printer. Do not operate the printer in an explosive atmosphere.
Do not block or cover the openings of the printer.
Do not attempt to modify the drying or curing module, or the e-cabinet.
Ensure that the operating temperature of the substrate recommended by the
manufacturer is not exceeded. If this information is not available, ask the
manufacturer. Do not load substrates that cannot be used at an operating
temperature above 125°C (257°F).
Fire hazard
5
loading