Idiomas disponibles
Idiomas disponibles
7
Step
Install the seat cushion
As shown in the figure, snap the button of the
seat cushion into the buckle hole of the panel
seat and fasten it.
8
Step
Assembly for Grip Strips
Insert five grip strips into corresponding holes
under the bottom tray respectively. Please make
sure they are pressed to the bottom to avoid
falling-off, and rubbing the floor.
9
Step
Install the music box
Unscrew the self-tapping screw of the battery cover
and remove the battery cover as shown in the
figure, then install the battery into the battery box
(Pay attention to the difference between "+" and "-",
it cannot be reversed),finally close the battery cover
and fix it with the self-tapping screw, press the
music button on the power switch to play music.
WARNING!
1. This product use 2 AA 1.5 V batteries.
2. The battery "+" and "-" direction cannot be installed in reverse.
3. Non-rechargeable batteries are not be recharged.
4. Rechargeable batteries can only be charged under adult supervision.
5. The rechargeable battery should be removed from the toy before charging.
6. Different types of batteries or old and new batteries can not be mixed.
7. The battery should be placed with the correct polarity.
8. Exhausted batteries should be removed from the toy.
9. Battery terminals can not be short-circuited.
10. Battery cannot be used as toys for children to play, so as to avoid danger.
06
Function operation
1
Step
Adjust the height
As shown in the figure, press the height
adjustment buttons of the three supporting feet,
and adjust the height of the walker by adjusting
the three supporting feet to the same height.
2
Step
The upper part can be converted into a walker toy
Press the fixed button on the upper wheel, remove the upper wheel and the
fixing parts, separate from the three supporting legs of the base frame, and
then put the wheels and the fixing parts back to their original places.
3
Step
Convert into Activity Walker
Press the fixing buttons on both sides of the bottom plate as shown in the figure, and
take out the bottom plate. Insert the rear wheel knob into the mounting hole until the
knob button can be stabilized on the rear wheel. Then turn the knob as needed to
adjust the speed of the rear wheel. （Turn the knob counterclockwise to increase the
speed of the wheel. Rotate the knob clockwise to slow down or lock the wheel.）
When the product returns to the baby walker, the rear wheel knob must be removed.
The operation is as follows: unscrew the knob completely against the direction of the
arrow, and then disconnect the knob outwards.
Main manufacturing
materials:
Plastic, plastic coating, chemical
fiber cloth, sponge
Tips
It is recommended that the use time limit
should not exceed 30 minutes to prevent
your child from playing under fatigue.
07
