Idiomas disponibles
Idiomas disponibles
Q: Could a QC3.0 port be applied to charge the device not support
quick charge?
A: Yes. The QC3.0 port will automatically recognize the voltage &
current of charging device. If it was connected to a QC2.0 or not
quick charge device, the voltage will be automatically set to 5V to
protect against over-voltage of the device.
Q: Why is the green light indication continuously blinking during
charging devices from USB Multiple-Port?
A: This blinking status due to the station over maximum output
loading leads to self- protection against over-heating. Detach some
charging devices or reduce its power output can instantly solve this
issue.
Q: Why the charging station stop working suddenly?
A: When the total power output exceeds the limit, the charging
station will stop charging automatically to protect the devices avoid
damage caused by over-voltage. Just remove some of the devices
and turn on the charging station, then you can continue to use it.
Note
１． When inserting the bracket, please pay attention to the insertion
slot, ensure that no space between the charging station and the bracket.
２． The space between the bracket should be adjusted according to
the thickness of the charging device and should not leave too much
space.
３． It is recommended that to charge the device with the original
USB charging cable. To avoid repeated insertion and removal of the
charging cable, you can use the AC power switch to disconnect the
power.
4
