Idiomas disponibles
Idiomas disponibles
CHART FOR MINIMUM
WIRE SIZE (AWG) OF EXTENSION
CORDS
NAMEPLATE
RATING AMPS - 0 - 10.0
Total Extension Cord Length (ft)
25
50
75
100
125
150
Wire Gauge
18
18
16
16
14
14
9. Use only the supplied
charger when charging
your unit. The use of any other charger
could damage
the battery or create a hazardous
condition.
10. Use only one charger when charging.
11. Do not attempt to open the charger or the unit. There are no customer serviceable
parts inside. Return to any authorized
Black & Decker service center.
12. DO NOT incinerate
battery packs even if they are severely
damaged
or completely
worn out.
13. Do not incinerate
the batteries.
They can explode
in a fire. A small leakage
of liquid
from the battery cells may occur under extreme
usage, charging
or temperature
conditions.
This does not indicate
a failure. However,
if the outer seal is broken and this
leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize
with a mild acid such as lemon juice or vinegar.
c.
If the battery liquid gets in your eyes, flush them with clean water for a minimum
of
10 minutes
and seek immediate
medical
attention.
MEDICAL
NOTE:
The liquid is a
25-35%
solution of potassium
hydroxide.
SAVE THESE INSTRUCTIONS
z IMPORTANT CHARGING SAFETY
INSTRUCTIONS
CHARGING
THE POWER
PACK
THE BATTERIES
IN YOUR POWER PACK ARE NOT FULLY CHARGED
AT THE
FACTORY. BEFORE ATTEMPTING
TO CHARGE
THEM, THOROUGHLY
READ ALL OF
THE SAFETY INSTRUCTIONS.
The charger is designed to use standard household
120 volt 60 Hz power.
1. Plug the charger into any standard
120 Volt 60 Hz electrical
outlet.
NOTE:
Do not charge
by means
of an engine
generator
or DC power
source,
Use
only
120V AC,
2. Slide the charger onto the power pack as shown in Figure 2 & 3 and let the power pack
charge
initially for 9 hours. After the initial charge,
under normal usage, your power
pack should be fully charged
in 3 to 9 hours.
3. Unplug charger, and remove the power pack. Place the power
pack in the unit and
be certain
that it is inserted
fully
into the battery
cavity
until it "clicks"
into place,
NOTE:
To remove the power pack from the unit, press down on the release button on
the back of the pack (Figure 4) and slide out.
IMPORTANT
CHARGING
NOTES
1. After normal usage, your power pack should be fully charged in 3 to 9 hours. If the
power pack is run-down
completely,
it may take up to 9 hours to become fully charged.
Your power pack was sent from the factory in an uncharged
condition.
Before
attempting
to use it, it must be charged
for at least 9 hours.
2. DO NOT charge the power pack in an air temperature
below +40°F(+4.5°C),
or above
+105°F (+40.5°C).
This is important
and will prevent serious
damage to the power
pack. Longest life and best performance
can be obtained
if power pack is charged
when air temperature
is about 75°F (24°C).
3. While charging,
the charger may hum and become warm to touch. This is a normal
condition
and does not indicate a problem.
4. If the power pack does not charge
properly--(1)
Check current at receptacle
by
plugging
in a lamp or other appliance.
(2) Check to see if receptacle
is connected
to a
light switch which turns power off when you turn out the lights. (3) Move charger
and
power pack to a surrounding
air temperature
of 40°F (+4.5°C)
to 105°F (+40.5°C).
(4) If
the receptacle
and temperature
are OK, and you do not get proper charging,
take or
send the power pack and charger to your local Black & Decker service center. See
Tools Electric in
yellow
pages.
5. The power pack should be recharged
when it fails to produce sufficient
power on jobs
which were easily done previously.
DO NOT CONTINUE
using unit with its power pack
in a depleted condition.
6. The power pack will reach optimum
performance
after being cycled 5 times during
normal usage. There is no need to run the batteries down completely
before recharging.
Normal usage is the best method of discharging
and recharging
the power pack.
LEAVING
THE BATTERY
PACK IN THE CHARGER
The charger and battery pack can be left connected
with the red light glowing indefinitely.
The charger will keep the battery pack fresh and fully charged.
NOTE:
A battery pack will slowly lose its charge when kept out of the charger. If the battery
pack has not been kept on maintenance
charge, it may need to be recharged
before use. A
battery pack may also slowly lose its charge if left in a charger that is not plugged into an
appropriate
AC source.
SWITCH
The switch can be operated
by moving the lever from side to side. The "ON" and "OFF"
positions
are marked on the housing as shown in Figure 1A & 1B.
CAUTION:
DO NOT POtNT
UNtT DISCHARGE
AT SELF OR
BYSTANDERS.
OPERATION
r-_ ^_
UTION : Always
wear safety glasses. Wear a filter mask if the operation
is dusty. Use of gloves,
long pants and substantial
footwear
is recommended.
Keep long
hair and loose clothing away from openings
and moving parts. THIS SWEEPER
IS FOR
HOUSEHOLD
USE ONLY.
NOTE:
Ensure the blower is switched off and the battery is removed
before attaching
or
removing
the sweeper
tube.
• TUBE ASSEMBLY
To attach the tube to the sweeper,
line up the tube with the sweeper
housing
as shown in Figure 5. Push the tube into the sweeper
housing until the lock button
engages the lock hole in the tube.
• OPERATION
Hold the sweeper
with one hand as shown in Figure 6 and sweep from side to side with
the nozzle several inches above the ground. Slowly advance keeping the accumulated pile of
debris in front of you.
MAINTENANCE
• CLEANING
AND STORAGE
TURN OFF UNIT!
"_, ^_
UTION :
Do NOT POUR OR SPRAY WATER ON THE UNIT.
Use only mild soap and a damp cloth to clean the unit. Never let any liquid get inside the
unit; never immerse any part of the unit into a liquid.
Your sweeper
should be stored in a dry place. Do not store the unit on or
adjacent
to fertilizers
or chemicals.
Such storage can cause rapid corrosion
of the metal parts.
THE RBRC
TM
SEAL
The RBRC
TM
(Rechargeable
Battery Recycling
Corporation)
Seal on the nickel-cadmium
battery (or battery pack) indicates
that the costs to
recycle the battery (or battery
pack) at the end of its useful life have already
been paid by Black & Decker. In some areas, it is illegal to place spent
nickel-cadmium
batteries in the trash or municipal
solid waste stream and the RBRC
program provides an environmentally
conscious
alternative.
RBRC in cooperation
with Black & Decker and other battery users, has established
programs
in the United States and Canada to facilitate the collection
of spent nickel-
cadmium
batteries. Help protect our environment
and conserve
natural resources by
returning
the spent nickel-cadmium
battery to an authorized
Black & Decker service center
or to your local retailer for recycling. You may also contact your local recycling
center for
information
on where to drop off the spent battery, or call 1-800-544-6986
Problem
TROUBLESHOOTING
Possible Cause
Possible Solution
• Unit will not start.
• Battery will not charge.
• Battery not installed properly.
• Battery not charged.
• Battery not inserted into charger.
• Charger not plugged in.
• Surrounding
air temperature
too hot or too cold.
• Check battery
installation.
• Check battery
charging
requirements.
• Insert battery into charger
until red LED appears.
• Plug charger into a working
outlet.
Refer to "Important
Charging Notes" for more
details.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle
is
connected
to a light switch
which turns power off when
you turn out the lights.
• Move charger and tool to a
surrounding
air temperature
of above 40 degree F(4,5°C)
or below 105 degree F
(+4o,5oc).
For assistance
with your product,
visit our website www.blackanddecker.com
for the
location of the service center nearest you or call the BLACK & DECKER
help line at
1-800-544-6986.
IMPORTANT
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
should be performed by authorized service centers or other qualified service organizations,
always using identical replacement parts.
SERVICE
INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you need technical
advice, repair, or
genuine factory replacement
parts, contact the Black & Decker location nearest you. To
find your local service location, refer to the yellow page directory under "Tools--Electric"
or
call: 1-800-544-6986
or visit www.blackanddecker.com
FULL TWO-YEAR
HOME
USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship.
The defective product will be replaced or repaired at no charge in
either of two ways.
The first, which will result in exchanges
only, is to return the product to the retailer from
whom it was purchased
(provided that the store is a participating
retailer). Returns should
be made within the time period of the retailer's policy for exchanges
(usually 30 to 90 days
after the sale). Proof of purchase may be required.
Please check with the retailer for their
specific return policy regarding
returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized
Service Center for repair or replacement
at our option. Proof of purchase may
be required.Black
& Decker owned and authorized
Service Centers are listed under
"Tools-Electric"
in the yellow pages of the phone directory.
This warranty does not apply to accessories.
This warranty gives you specific legal rights
and you may have other rights which vary from state to state or province to province.
Should you have any questions,
contact the manager of your nearest Black & Decker
Service Center. This product is not intended for commercial
use.
FREE WARNING
LABEL REPLACEMENT:
If your warning labels become illegible or are
missing, call 1-800-544-6986
for a free replacement.
See
'Tools-
Imported
by
Electric'
I'_1
Black
& Decker
(U.S.)
Inc.,
- Yellow
Pages
-
701 E. Joppa
Rd.
for Service
&
Towson,
MD 21286
U.S.A.
Sales
GUIDE D'UTILISATIOH
Code de date
Num_ro
de catalogue
: NSl18,
NS118G,
NS118L
AVANT DE RETOURNER
CE PRODUIT POUR QUELQUE
RAISON QUE CE SOIT, COMPOSER
LE
1-800-544-6986
AVANT D'APPELER, AYEZ EN MAIN LE N ° DE CATALOGUE ET LE CODE DE DATE. DANS LA PLUPART
DES CAS, UN REPRESENTANT
DE BLACK & DECKER PEUT RESOUDRE LE PROBLEME PAR
TELEPHONE. SI VOUS AVEZ UNE SUGGESTION
OU UN COMMENTAIRE,
APPELEZ-NOUS.
VOS
IMPRESSIONS
SONT CRUCIALES
POUR BLACK & DECKER.
RENSEIGNEMENTS
IMPORTANTS
• Avant de faire fonctionner
I'outil, s'assurer que le tube de soufflage est verrouille
en place.
• II faut charger la pile pendant 9 heures avant d'utiliser I'outil.
CONSERVER
LE PRI SENT
GUIDE h. TITRE DE
REFERENCE.
AVERTISSEMENT
:
Directives
et consignes
de
s6curit6 importantes.
AFIN DE RI_DUIRE LES RISQUES
DE BLESSURES
:
• Avant toute utilisation,
s'assurer
que tous ceux qui se servent de I'outil lisent et
comprennent
toutes les mesures de securit6 et tout autre renseignement
contenus
dans le
present guide.
• Conserver
ces mesures et les relire frequemment
avant d'utiliser
I'outil ou d'en expliquer
le
fonctionnement
& d'autres personnes.
• Ne pas pointer I'orifice de sortie de I'outil vers sol ni vers d'autres personnes.
• €:loigner les cheveux longs et les v6tements
amples des ouvertures
et des pieces en
mouvement.
