Idiomas disponibles
Idiomas disponibles
3 - LED lighting
4 - Nozzles
5 - Pump
6 - Extension tubes
7 - Support
8 - Remote control
3.2.
Installation of the unit
1) Carefully unpack all components
2) Place the pump under water and make sure it is completely submerged in water. If the pump
pipe is too far from the water surface, stones or bricks can be placed under the pump. Do not
use the device in salt water.
3) Install the appropriate number of extension tubes and a nozzle on the pump outlet.
4) Install the support on the back of the solar panel and place it on a dry surface. The solar panel
should face the sun. Make sure that nothing blocks the sun's rays from falling on the solar
panel.
5) Connect the pump cable to the socket in the controller housing on the back of the solar panel;
6) Connect the LED lighting cable (optional) to the socket in the controller housing;
7) Adjust the water flow if necessary.
8) The unit is now ready for use.
3.3.
Working with the device
Remote control buttons:
A: Press this button to run the pump for 1-4 hours of operation.
One press - work for one hour, two presses - work for two hours, three presses - work for three
hours, four presses - work for four hours. The indicator light will flash several times and the
number of flashes will indicate the current setting, e.g.: if set for 2 hours, the indicator light will
flash twice. Press button D to turn off the pump.
B: Press this button to turn on/off the LED lights.
C: Press this button to control the water pressure, there are five levels of water pressure.
D: Press this button to turn on the pump without time setting, until the batteries are exhausted.
Press this button again to turn off the pump.
Charging the battery: Switch off the pump and charge the battery with solar energy. Ensure that
the solar panel has access to sunlight.
Battery status:
When the pump is ON : The color of the indicator light shows the battery status as below.
When the pump is turned OFF: Press the "C" button, and the indicator light will flash for 5
seconds to indicate the battery status as shown below.
Green : The battery is fully charged. The pump will run for about 4-5 hours.
Orange : The battery is half charged. The pump will run for about 1-3 hours.
Red : The battery needs recharging. The pump will run for less than 1 hour.
